Apollo Monitor Module

vf5663  

VF5663
Priority Switch Monitor Module

ULstamp

The Priority Switch Monitor Module is designed to monitor the state of one or more single pole, volt free contacts and to report the status to Apollo compatible analog control equipment. It can also place a signal on the loop to provide early warning if a device such as a pull station is operated.


Standard Features

  • Three input states – “normal”, “Fault”, and “alarm”
  • Loop powered
  • Fast response time
  • Interrupt facility
  • Mounts on a 2-gang or 4x4 box
  • Visible LED

vf5664  
VF5664
Dual Priority Switch Monitor Module

The VF5664 Dual Priority Switch Monitor Module contains two priority switch monitor modules (55000-806) on a single plate.


Standard Features

  • Loop powered
  • Fast response time
  • Interrupt facility
  • Mounts on a 2-gang or 4x4 box
  • Two visible LEDs

vf5665  

VF5665
Input / Output Module
 






The Switch Monitor Input/Output Module provides a voltage free, single pole, change-over relay output, a single, monitored switch input and unmonitored, non-polarized opto-coupled input.


Standard Features

  • It can report fault, switch open and switch closed levels
  • Loop powered
  • Mounts on a 2-gang or 4x4 box
  • Visible LED

vf5666  

VF5666
Sounder Control Module





 

The Sounder Control Module monitors and controls the operation of a zone of conventional sounders and reports their status to the control panel.


Standard Features

  • Allows sounders to be operated continuously or be pulsed, 1 second on, 1 second off
  • May be synchronized when in pulsed operation
  • Can also be used for public address speakers
  • Visible LED

vf5667  

VF5667
Relay Output Module





 

The Relay Output Module provides a single 2-pole changeover relay.


Standard Features

  • Loop Powered
  • Can be placed anywhere on loop
  • Visible LED

vf5608  

VF5608
Mini Input Module





 

The New Mini Monitor Module is an interface within a entirely new housing. This allows the unit to be fitted onto a standard 35mm DIN-rail (using a twist-click motion) or mounted within an enclosure, for example a manual call point. It is designed to monitor the state of one or more single pole, volt free contacts connected on a single pair of cables and to report the status to Apollo compatible analogue control equipment.


Standard Features

  • Designed for use where space is limited
  • Features a short circuit isolator as standard
  • Interrupt/non interrupt in one unit
  • “Pre-alarm” status available
  • LED status indication (Yellow - Fault, Green - Polling, Red - Alarm)
  • DIN Rail mountable

vf5660  

 

VF5660
Mini Priority Switch Monitor Module





 

The Mini Priority Switch Monitor is designed to monitor the state of one or more single pole, volt free contacts and to report the status to Apollo compatible analog control equipment. It can also place a signal on the loop to provide early warning if a device such as a pull station is operated.


Standard Features

  • Three input states – “normal”, “fault” and “alarm”
  • Visible LED with remote LED connection option
  • Loop powered
  • Designed to fit into equipment with limited space
  • Easy to install
  • Monitors equipment where a fast response is required
  • Interrupt facility
  • Class A or B input capability